PENGARUH LUAS AREA CETAK TERHADAP PERMEABILITAS MEMBRAN POLYSULFONE
EFFECT OF CASTING AREA ON POLYSULFONE MEMBRANE PERMEABILITY
Pada penelitian ini telah dilakukan pembuatan membran menggunakan metode inversi fasa dengan teknik imersi presipitasi dan pencetakan menggunakan casting knife. Lebih lanjut, evaluasi pengaruh luas area cetak terhadap karakteristik dan kinerja membran polysulfone dalam pemisahan rhodamine-B dan asam humat dilakukan untuk menentukan luas area cetak optimum. Karakterisasi membran menggunakan Fourier Transform Infra-red (FTIR) telah memastikan terbentuknya membran polimer PSf. Hasil evaluasi menggunakan mikrometer sekrup menunjukkan penurunan ketebalan membran yang dihasilkan seiring dengan meningkatnya luas area cetak. Secara spesifik, penurunan ketebalan yang dimaksud adalah dari 0,250 mm menjadi 0,146 mm ketika luas area cetak ditingkatkan dari 140 cm2 menjadi 196 cm2. Secara berkebalikan, hasil uji kinerja membran yang terukur dari nilai fluks menunjukkan peningkatan fluks air dari 599,26 L/m2.jam menjadi 1.412,53 L/m2.jam ketika diaplikasikan peningkatan luas area cetak yang sama. Lebih lanjut, pola peningkatan fluks yang sama juga terdeteksi pada pemisahan rhodamine-B dan asam humat menggunakan membran PSf. Kata kunci: Membran, polysulfone,, Luas Area Cetak
In this research, a membrane was made using the phase inversion method with precipitation immersion technique and casting using the casting knife. Furthermore, evaluation of the effect of cast area on the characteristics and performance of polysulfone membranes in the separation of rhodamine-B and humic acid was carried out to determine the optimum cast area. The characterization of membranes using Fourier Transform Infra-red (FTIR) confirmed the formation of PSf polymer membranes. The evaluation results using a screw micrometer showed a decrease in the resulting membrane thickness along with the increase in the cast area. Specifically, the reduction in thickness referred to is from 0.250 mm to 0.146 mm when the cast area is increased from 140 cm2 to 196 cm2. In contrast, the measured membrane performance test results from the flux value showed an increase in water flux from… L/m2.hour to… L/m2/hour when the same increase in cast area was applied. Furthermore, the same pattern of increased flux was detected in the separation of rhodamine-B and humic acid using the PSf membrane.
Keywords: Membrane, Polysulfone, Large print area