Rancang Bangun PLTS Portable Untuk Supply Mobile Charger Berbasis Internet of Things
Design And Build Portable PV Mini-Grid For Mobile Charger Supply Based On Internet Of Things
Diperlukan proses charging pada penggunaan ponsel yang praktis agar ponsel tidak mati karena kehabisan daya pada baterai dan ponsel dapat terus digunakan. Penelitian ini bertujuan untuk merancang bangun PLTS portable yang mudah dibawa atau dipindah tempat dan dapat digunakan untuk supply mobile charger pada proses charging baterai ponsel berbasis Internet of Things dengan aplikasi Blynk sebagai interface serta ESP8266 dan ATmega328P sebagai mikrokontroler. Metode yang digunakan adalah jenis pendekatan eksperimen dengan pengumpulan data dilakukan melalui pengujian tanpa beban dengan mengukur tegangan dan arus yang dibangkitkan oleh pembangkit surya, dan pengujian berbeban dengan mengukur tegangan accu pada saat pengisian accu, mengukur beban AC pada kondisi charging rangkaian terhubung dengan panel surya, dan mengukur beban AC pada kondisi discharging rangkaian hanya menggunakan accu sebagai suplai energi. Pada pengujian tanpa beban diperoleh hasil output tegangan dan arus sebesar 14.77V dan 1.55A. Pada pengujian pengisian accu diperoleh penambahan tegangan accu sebesar 0.72V. Pada pengujian accu kondisi charging, nilai tegangan accu sebesar 12.78V – 12.71V dengan penambahan baterai ponsel sebesar 32%. Pada pengujian accu kondisi discharging, nilai tegangan accu mengalami penurunan sebesar 0.03V saat diberi beban 0.7A dengan penambahan baterai ponsel sebesar 32%. Rancang bangun PLTS portable bekerja secara efektif untuk digunakan sebagai supply mobile charger pada proses charging baterai ponsel saat berada diluar ruangan atau di fasilitas umum.
Kata kunci: Blynk, Internet of things, Mobile charger, PLTS portable
A practical charging process is needed on the use of mobile phones so the mobile phone does not turn off due to running out of battery power and the phone can continue to be used. This study aims to design a portable solar power plant that is easy to carry or move and can be used to supply mobile chargers in the process of charging mobile phones based on the Internet of Things with the Blynk application as an interface and ESP8266 and ATmega328P as microcontrollers. The method used is an experimental approach with data collection carried out through no-load testing by measuring the voltage and current generated by the solar generator, and load testing by measuring the battery voltage when charging the battery, measuring the AC load on the charging condition of the circuit connected to the solar panel, and measure the AC load in the discharging condition of the circuit using only the battery as an energy supply. In the no-load test, the output voltage and current were 14.77V and 1.55A. In the battery charging test, an additional battery voltage of 0.72V was obtained. In the battery charging condition test, the battery voltage value is 12.78V – 12.71V with the addition of a cell phone battery of 32%. In the battery discharging condition test, the battery voltage value decreased by 0.03V when given a load of 0.7A with the addition of a cell phone battery of 32%. The design of a portable solar power plant works effectively to be used as a supply of mobile chargers in the process of charging mobile phones while outdoors or in public facilities.
Keywords: Blynk, Internet of things, Mobile charger, PLTS portable