Mesin Gergaji merupakan alat perkakas yang berguna untuk memotong benda kerja. Mesin perkakas ini biasanya digunakan oleh sebagian besar industri dari skala kecil hingga besar, penggunaan sistem pneumatic electric dalam pengolahan bahan mentah kayu masih belum banyak ditemui di pasaran. Umumnya proses pengolahan kayu yang dilakukan oleh para pekerja/pengrajin masih konvensional, melelahkan, aspek keselamatan K3 yang kurang.
Tujuan penelitian ini yaitu untuk mengetahui komponen yang dibutuhkan, setting komponen, spesifikasi tiap komponen, performa komponen pada trainer mesin gergaji sistem pneumatic electric berbasis PLC. Untuk mencapai dalam pembuatan mesin, maka penilitian menggunakan metode R&D (Research and Development) yaitu penelitian pengembangan berbasis eksperimen. Berdasarkan penelitian yang telah dilakukan maka dapat disimpulkan sebagai berikut:
(1) sistem instrumentasi trainer termasuk kedalam jenis sistem Open Loop karena tidak adanya feedback berupa sensor terhadap hasil pemotongan kayu; (2) komponen yang digunakan untuk membentuk sistem instrumentasi trainer meliputi: Double Acting Cylinder (dengan Panjang through 270 mm, Diameter luar 20mm, diameter piston 8 cm), Limit Switch Z-15GW2-B, Push Button, PLC Omron CP1H-X40DRA, Kompresor Matrix OFS750-25 1 HP, Relay Omron LY2N 24 VDC, Solenoid Valve FESTO MFH 3-0,9 107, Flow Control Valve SPC ST-01; (3) setting komponen telah dilakukan dengan cermat dan teliti sehingga trainer bekerja dengan baik; (4) berdasarkan hasil uji peforma komponen maka dapat diketahui bahwa semua komponen bekerja dengan baik dan sesuai dengan tujuan dari rancangan sistem instrumentasi.
Kata Kunci: sistem instrumentasi, mesin gergaji, sistem pneumatic electric
A sawing machine is a tool that is useful for cutting workpieces. This machine usually used by most industries from small to large scale, the using of a pneumatic electric system on processing wood raw materials still not widely and rarely found in the market. So Generally wood processing which carried out by workers / craftsmen still conventional, exhausting, and safety aspects of K3 are lacking The purpose of this research is to find out the required components, component settings, specifications of each component, performance of components in a pneumatic sawing machine trainer based on PLC. To achieve the manufacture of machines, the research using R & D (Research and Development) method, which is experimental-based development research. the research that has been done, it can be concluded as follows: Trainer instrumentation system are Open Loop type because there is no sensor feedback on the results of cutting wood; (2) the components used to form the trainer instrumentation system are: Double Acting Cylinder (with 270 mm length, 20 mm outer diameter, 8 cm piston diameter), Z-15GW2-B Limit Switch, Push Button, Omron CP1H-X40DRA PLC, Compressor OFS750-25 1 HP Matrix, Omron LY2N 24 VDC Relay, Solenoid Valve FESTO MFH 3-0,9 107, SPC ST-01 Flow Control Valve; (3) the component settings have been carefully carried out so that the trainer works well; (4) based on the component performance test results, it can be seen that all components work well and in accordance with the objectives of the instrumentation system design.
Keyword:Instrumtention System,Saw Machine,Pneumatic electric systems,Trainer