Pengaruh Konsentrasi Kloramfenikol Terhadap Adsorpsi Polimer Cetak Molekul dengan Metode Presipitasi
Effect of Chloramphenicol Concentration on Molecularly Imprinted Polymer Adsorption Using Presipitation Method
Penelitian ini bertujuan untuk mensisntesis Molecularly Imprinted Polymer (MIP) yang dapat digunakan sebagai adsorben pada adsorpsi kloramfenikol (CAP). Kinerja adsorben MIP diuji adsorpsinya dengan variasi konsentrasi CAP awal. Konsentrasi CAP yang digunakan yaitu 10, 25 dan 50 ppm. Karakterisasi Polimer MIP, Non-Imprinted Polimer (NIP), dan Polimer Blanko (PB) yang dihasilkan dianalisis menggunakan Fourier Transform Infrared (FTIR), untuk mengetahui gugus -NO2. Hasil penelitian menunjukkan semakin besar konsentrasi CAP awal maka kemampuan adsorpsi semakin meningkat pada MIP dan PB. Kemampuan adsorpsi terbesar pada penelitian ini untuk MIP yaitu 16,54 mg/g dan PB yaitu 8,78 mg/g pada konsentrasi 50 ppm. MIP memiliki kemampuan adsorpsi lebih tinggi daripada PB karena adsorpsi MIP yang spesifik terhadap CAP. Nilai imprinting factor (IF) yang didapatkan sebesar 1,88. Hasil FTIR menunjukkan adanya gugus –NO2 pada bilangan gelombang 1560,62 cm-1 pada MIP dengan intensitas yang lebih rendah daripada NIP. Hal tersebut menunjukkan adanya CAP yang telah terelusi pada proses ekstraksi.
The aims of this study to synthesize Molecularly Imprinted Polymer (MIP) which can be used as adsorbents for chloramphenicol adsorption (CAP). The performance of the MIP adsorbent was tested for adsorption with variations in the initial CAP concentration. The CAP concentrations used were 10, 25 and 50 ppm. The characterization of the resulting MIP, Non-Imprinted Polymer (NIP), and Blank Polymer (PB) were analyzed using Fourier Transform Infrared (FTIR), to determine the -NO2 group. The results showed that the greater the initial CAP concentration, the higher the adsorption capability in MIP and PB. The largest adsorption capability in this study for MIP was 16.54 mg/g and PB was 8.78 mg/g at a concentration of 50 ppm. MIP has a higher adsorption capability than PB due to the specific adsorption of MIP to CAP. The imprinting factor (IF) value obtained is 1.88. FTIR results showed the presence of –NO2 group at wave number 1560.62 cm.-1 in MIP with a lower intensity than NIP. This indicates the presence of CAP that has been eluted in the extraction process.