Perbandingan Beton Mutu Tinggi Dengan Pengaplikasian High Volume Fly Ash Tipe C dan Tipe F
Comparison of High-Performance Concrete Using Type C and Type F High-Volume Fly Ash
Penggunaan beton sebagai material konstruksi utama terus berkembang seiring tuntutan akan material yang ramah lingkungan dan berkelanjutan. Beton HVFA menggantikan sebagian besar semen dengan fly ash, yang dapat meningkatkan sifat mekanis dan durabilitas beton. Metode eksperimen dilakukan pengujian kekuatan tekan terhadap campuran beton yang menggunakan proporsi fly ash sebesar 50% dan 60%. Sampel yang diterapkan dalam penelitian ini adalah silinder beton berukuran 15x30 cm dengan penambahan Superplasticizer Dynamon sebagai admixture. Hasil penelitian menunjukkan bahwa rasio substitusi optimum fly ash tipe C terhadap semen adalah 60%, dengan kekuatan tekan rata-rata 40,3 MPa untuk tiga benda uji pada usia 14 hari. Sebaliknya, rasio optimum untuk fly ash tipe F adalah 50%, menunjukkan hasil kekuatan tekan rata-rata sebesar 35,2 MPa. Penggunaan fly ash di atas 50% menghasilkan kekuatan tekan yang lebih rendah dibandingkan sampel yang digunakan sebagai kontrol, yang memiliki kekuatan tekan rata-rata 42,7 MPa.
The use of concrete as a primary construction material continues to evolve in response to the growing demand for environmentally friendly and sustainable materials. HVFA concrete replaces a significant portion of cement with fly ash, which can enhance the mechanical properties and durability of the concrete. The experimental procedure involved testing the compressive strength of concrete mixtures incorporating fly ash at proportions of 50% and 60%. The samples used in this research were concrete cylinders measuring 15x30 cm, with the addition of Superplasticizer Dynamon as an admixture. The results indicate that the optimum substitution ratio of type C fly ash for cement is 60%, with an average compressive strength of 40.3 MPa for three test specimens at 14 days of age. In contrast, the optimum ratio for type F fly ash is 50%, yielding an average compressive strength of 35.2 MPa. The use of fly ash above 50% resulted in lower compressive strength compared to the control samples, which had an average compressive strength of 42.7 MPa.